FAQ
Default solution folder, feel free to edit or delete it.
3D design should be imported to .stl file, it can have at most 250 x 250 x 200 mm (9.84*9.84*7.87 inches) of dimensions, it needs to be properly adjusted...
Fri, 10 Oct, 2014 at 4:12 PM
Yes, you can have different infills for your object, which can be varied through different levels in slicer software.
Lesser percentage of infill will ...
Mon, 30 Jun, 2014 at 5:45 PM
Currently Accucraft i250 can print ABS and PLA with filament diameter 1.75 mm.
Fri, 10 Oct, 2014 at 4:12 PM
To make sure prints are fine the first layer needs to adhere to the base plate firmly, to achieve this glue application is necessary.
Tue, 2 Sep, 2014 at 11:11 AM
The grid is only needed when part surface area is very small, otherwise you can turn this off from kisslicer. (Please have a look at page no 39)
Mon, 30 Jun, 2014 at 6:19 PM
Nozzle needs to be changed if it gets blocked due to dust accumulation, or after consumption of one filament spool.
A. Changing the extruder Noz...
Mon, 4 Aug, 2014 at 11:57 AM
You can directly click on run job after loading gcode file in repetier, and Accucraft will start printing, but in this case it will wait for the temperature...
Tue, 8 Jul, 2014 at 5:31 PM
This issue can arise due to following issues:
1. Your computer is set to sleep mode :
In this case your computer will enter sleep mode (by def...
Tue, 8 Jul, 2014 at 11:49 PM
This issue arises mainly when the wrong placements of spool holder or excessive feed or flow rate settings or dust accumulation on filament spool.
To sol...
Sat, 2 Aug, 2014 at 10:27 AM
Check if spool is not jammed up and fitted with correct direction as shown in manual page no 28.
After clearing spool jamming remove the feeder t...
Sat, 2 Aug, 2014 at 10:26 AM