• Switch on your pc and machine

  • Connect USB cable to Accucraft i250 and PC

  • To open your design click on open in Kisslicer

  • Check the settings and adjust the 3d model correctly at the centre of the build plate

  • Make sure it is an error free file

  • Now click on slice

  • And save the file anywhere with strictly .gcode file

  • Now go to manual settings and set the z axis height to 70mm so as to lower your build plate.

  • Now clean the build plate

  • Apply glue evenly on the bed

  • Click on run job

  • Your print will be initiated (after heated bed an nozzle temperature reaches to target temperature)