Getting Started
Default solution folder, feel free to edit or delete it.
Any prototype with minimum wall thickness 1.2mm and minimum overall size more than 2mm and less than 250mm x 250mm x 200mm (length x Width X Height) can ...
Fri, 10 Oct, 2014 at 4:12 PM
Switch on your pc and machine
Connect USB cable to Accucraft i250 and PC
To open your design click on open in Kisslicer
Check the settin...
Tue, 8 Jul, 2014 at 5:39 PM
Attaching the spool holder:
1. The spool holder attaches to the back of the machine.
2. Take the spool holder and attach it to the machine back (as sh...
Tue, 8 Jul, 2014 at 6:21 PM
Please make sure you have a filament spool positioned over the spool holder, guided along the filament guide, with the filament in counter clockwise directi...
Tue, 8 Jul, 2014 at 6:43 PM
If the build plate is too far away from the nozzle your 3D-print might not stick to the build plate. Equally, if you adjust the build plate too close to t...
Tue, 8 Jul, 2014 at 9:47 PM
3D printing process for Accucraft is divided into 3 basic steps:
Orientation
Slicing
Printing
Orientation:
a) In order to give...
Tue, 8 Jul, 2014 at 11:54 PM
In this case you will have to clean the extruder gear and nozzle, Here is the process:
After continuous usage of the machine, once in a month the ...
Wed, 9 Jul, 2014 at 5:55 PM
Support Removal
Below image shows how the part looks like when it has overhangs.
· After print is finished wait for 5-10 minutes s...
Wed, 9 Jul, 2014 at 6:00 PM
Usually clogging will happen due to following reasons:
1. sensor is loose ( so temperature goes much higher than it is displayed on the screen ) resul...
Mon, 18 Jan, 2016 at 5:37 PM
When you are going to start the check the simple steps.
Thu, 13 Apr, 2017 at 4:27 PM